Cutting conditions of long flutes
The cutting‑condition table for the EDL is not included in the catalog, but the feed and spindle speed should be adjusted according to the tool overhang, bas... 詳細表示
counterboring Do you need Pilot hole...
If the machining environment (workpiece shape, machine, etc.) is sufficiently rigid, consider counterboring machining from a state where there is no Pilot ho... 詳細表示
What is an end mill flute length ?
It is the length with peripheral cutting edge from the tip. (It is not the length of the flute.) Name of each part of the end mill (1) Flute (2) Shank ... 詳細表示
Multiple flutes Carbide end mill HY-HSCM-P is capable of high-efficiency machining that of conventional two-flute end mills, which is about three times more ... 詳細表示
Whether or not HY-HSCM-P can be regri...
The regrinding of the HY-HSCM-P is possible. * The total length changes because the cutting edge is cut. 詳細表示
HY-QCC regrinding is not possible. 詳細表示
It is possible from φ5 or more to regrinding . (Except in case of excessive damage) Tool regrinding and recoating are available at OSG. If you wish, p... 詳細表示
It is possible from φ5 or more to regrinding . (Except in case of excessive damage) Tool regrinding and recoating are available at OSG. If you wish, p... 詳細表示
Can the plunging at the end mill be e...
In a typical end mill, it is not possible to process the bottom surface flat only with plunging . The reason is that the end cutting edge is not flat. If y... 詳細表示
What is an end mill with a nick End m...
What is an end mill with nick (end mill end mill for semi-roughing ) An end mill with a nick is an end mill with a nick in the middle of the flute of a ... 詳細表示
Results:39 ,Showing: 21 - 30