How to machine right-angle shapes wit...
How to machine right-angle shapes with an end mill? Sharp Corner Edge Gaze In order to machine a right-angle shape with an end mill, the tool side that ... 詳細表示
Can AE-CRE-H regrinding ? It is possible from φ8 or more to regrinding . (Except in case of excessive damage) Tool regrinding and recoating are avail... 詳細表示
How to calculate cutting conditions d...
How to calculate cutting conditions during helical machining Rotation speed, feed rate, distance traveled in the Z-axis direction per helical lap Learn how ... 詳細表示
counterboring Do you need Pilot hole...
If the machining environment (workpiece shape, machine, etc.) is sufficiently rigid, consider counterboring machining from a state where there is no Pilot ho... 詳細表示
end cutting edge Do you have flat en...
Do you have an end mill that end cutting edge flat? If you are asked if there is an end mill with a flat end cutting edge , the tool to be selected depends ... 詳細表示
How much processing conditions should...
The longer the amount of protrusion relative to the diameter of the tool, the more vibration and deflection will occur during machining. By lowering the cond... 詳細表示
What is an end mill flute length ?
It is the length with peripheral flute from the tip. (It is not the length of the groove.) ） Name of each part of the end mill (1) Groove (2) Shank (3)... 詳細表示
Can AE-HFE-H regrinding ? It is possible from φ8 or more to regrinding . (Except in case of excessive damage) Tool regrinding and recoating are avail... 詳細表示
What is AE-HFE-H? Radius End Mill Com...
What is AE-HFE-H? AE-HFE-H is a radius end mill composite R type for high-hardness steel, which enables high-speed and high-feed machining, especially in ma... 詳細表示
This is a carbide end mill dedicated to 45° back chamfering. In general, "right-edge, right-handed, right-twisted" front/back tools tend to be "negative c... 詳細表示
Results:39 ,Showing: 11 - 20