Straight‑flute molding end mills are sometimes referred to as slotting tools. (The helix angle of the flute is 0°.) There are applications that are assumed ... 詳細表示
When using the FX-ZDS end mill for ca...
Not required for FX-ZDS. For VP-ZDS in powder metallurgy HSS , Pilot hole is required. ( Pilot hole diameter is recommended to be at least 50% of the diamete... 詳細表示
Can the plunging at the end mill be e...
Can the plunging at the end mill be enough to flatten the bottom? In a typical end mill, it is not possible to process the bottom surface flat only with plu... 詳細表示
What is the difference between 2 and ...
In general, slotting and drilling are difficult to discharge chips, and other processes that require a two-flute end mill to be used. For machining that is ... 詳細表示
What are OH1 and OL1? What is the flu...
In OSG end mills, the symbols "OH~" and "OL~" indicate the end mill diameter tolerance. * The ~ part of "OH~" and "OL~" contains a number to indicate the de... 詳細表示
Since there is a "keyway standard" defined by JIS for keyways, it is recommended that you check the width and depth of the keyway before machining before sel... 詳細表示
What is helical machining? Helical machining refers to processing that uses planetary motion by the X, Y, and Z three-axis simultaneous control function... 詳細表示
Tools for processing ceramics If the state of the ceramics is semi-sintered, try using a diamond-coated tool. For sintered ceramics, choose the electrodepo... 詳細表示
Is it possible to regrinding an end m...
Both AM-EBT (ball) and AM-CRE (radius) are regrinding possible. Recoating is also recommended to ensure performance. If you are considering regrindin... 詳細表示
Cutting conditions of long flutes
The cutting‑condition table for the EDL is not included in the catalog, but the feed and spindle speed should be adjusted according to the tool overhang, bas... 詳細表示
Results:39 ,Showing: 1 - 10