What is a screw in MT6×0.75 grease ni...
MT6×0.75 screws and grease nipples are external thread standard. (JIS B 1575) external thread is 1/16 taper, but internal thread is a parallel thread and can... 詳細表示
Difference Between UNF and UNJF Pilot...
The pilot holes of the taps of the 467UNF and UNJF threads are different. The UNJF for aerospace applications has a larger minor diameter (pilot hole). 詳細表示
It is important to note that there are various interpretations of the expression "machine tap". In Japan, there are many cases where it is one of the foll... 詳細表示
Example of processing conditions for ...
The cutting conditions when machining SS400 with TPT, PT1/4, a tap for tapered thread machining for pipes, are as follows: A cutting speed of 3~6m/min is ... 詳細表示
Differences in tap materials (SKS and...
Both refer to the base material used for tapping. SKS is an alloy tool steel. ・HSS is called high-speed tool steel. The main difference between the two... 詳細表示
BA thread refers to the type of thread called BA in the British Standard BS, and the thread angle is 47.5 degrees. For example, if size is "2BA", then 2 r... 詳細表示
When plating a internal thread , wha...
The amount of tap oversize required for the plating process is calculated from the plating coating thickness . When it is considered that the diameter of ... 詳細表示
Tap processing of titanium 2 types (...
Tap processing of titanium 2 types (TB340) Two types of titanium (TB340) are pure titanium without heat treatment, and we recommend the Tap "EX-SUS-SFT... 詳細表示
What is a interrupted -shaped tap?
A interrupted -shaped tap is a type of tap for tapered threads, in which the thread of the complete tap thread is removed so that it jumps into a single thre... 詳細表示
Ichirin (一厘) is the unit used to represent size in inches. 1 inch = 25.4 mm 1 minute (ichibu) = 1/8 inch = 3.175 mm Ichirin (一厘) = 1/10 of 1 minute ... 詳細表示
Results:76 ,Showing: 1 - 10