Are there any taps that can be proces...

Are there any taps that can be processed by 6H? 6H stands for internal thread accuracy. Is there a tap that can be processed with a internal thread accurac... 詳細表示

Tapping into resin What kind of tap i...

Since there are various types of resins, different taps are suitable for different properties. Thermoplastic resins: Acrylic, vinyl chloride (PVC), etc. T... 詳細表示

Tap processing for Hastelloy C22 and...

Tap processing for Hastelloy C22 and C276 For Tap processing of Hastelloy C22 and C276, A-SFT and EX-SUS-SFT are recommended if they have been settled. As a... 詳細表示

Oversized taps for hot-dip galvanizing

Oversize taps for hot-dip galvanizing Hot-dip galvanizing is also known as dobu plating. Due to the thick plating coating thickness , we do not have a s... 詳細表示

external center spiral fluted tap n...

Normally, there is a protrusion " external center " at the tip of the spiral fluted tap attached to M6 or lower. 詳細表示

Tap processing of titanium 2 types (...

Tap processing of titanium 2 types (TB340) Two types of titanium (TB340) are pure titanium without heat treatment, and we recommend the Tap "EX-SUS-SFT... 詳細表示

Tool selection based on HRC hardness

Tool selection based on HRC hardness When the material to be machined is not listed in the corresponding material column of the catalog, or when the propert... 詳細表示

What is an oversized tap?

What is Upper Thirds Tap? At the request of customers such as "tight when external thread is inserted", "plating on internal thread ", "strain countermeasur... 詳細表示

What if I remove the bite part of the...

Once the chamfer is removed, it cannot be cut. chamfer is the part of the "cutting edge" that is cut by tapping. If you don't have enough pilot hole d... 詳細表示

Is it possible to share a tap with UN...

0.5625-18UNJF is the inch notation of 9/16-18UNJF. Even with 9/16-18UNF taps, the shape of the internal thread is the same, so if the accuracy is correct, m... 詳細表示