Cutting condition example for Taper P...

The recommended cutting speed for machining SS400 with a Taper Pipe Tap (TPT, PT1/4) is 3 to 6m/min. The gauge diameter (reference diameter) of 13.157mm is ... 詳細表示

Tap whitworth screws for W threads

Only those with size in inches are in the standard lineup. General use (HT, SFT, POT) General Use Long Shank (HT, SFT, POT) For SUS (SFT, POT) NT (Nut ... 詳細表示

Why does thread thinning occur even w...

Are you using a float-type tapping holder together with the synchronous feed mechanism? Even if the machine synchronizes the feed to one pitch per revolutio... 詳細表示

What is an Increasing Diameter Tap?

The number varies depending on the material and shape to be processed, but it is a set of multiple taps (the diameter of the screw gradually increases), and ... 詳細表示

There is a P or B on the shank of the...

The “P” and “B” markings on the forming‑tap shank indicate the chamfer length. In the New Roll Tap (NRT) series, “P” (Plug) is used for through‑hole machinin... 詳細表示

What is a interrupted -shaped tap?

A interrupted -shaped tap is a type of tap for tapered threads, in which the thread of the complete tap thread is removed so that it jumps into a single thre... 詳細表示

Ichirinbuto

Ichirin (一厘) is the unit used to represent size in inches. 1 inch = 25.4 mm 1 minute (ichibu) = 1/8 inch = 3.175 mm Ichirin (一厘) = 1/10 of 1 minute ... 詳細表示

Pilot Hole Diameters for Metric Threa...

Recommended Drill size for Thread Forming Forming Taps (NRT/XPF Series) * Currently, Hi-Roll tap (HRT series) is discontinued. 詳細表示

What are the key points for processin...

Spiral fluted taps are suitable for blind hole tapping because the spiral flutes evacuate chips toward the shank. However, they are prone to issues such as ... 詳細表示

Are there any taps that can be proces...

Are there any taps that can be processed by 6H? 6H stands for internal thread accuracy. Is there a tap that can be processed with a internal thread accurac... 詳細表示