Does the tapped thread make it skinny...

In the tapping process, the state in which the thread of the internal thread is thin, as if it has been gouged out, is called "Overcutting". There are severa... 詳細表示

Ichibu Nib Sambu What does it mean?

In conversations with customers, we sometimes use the expression "I want a tap of Sambu." Sambu is one of the so-called industry terms, and the size of the ... 詳細表示

What should be done if the machine st...

Tapered pipe tapping tends to require 2 to 3 times more torque than parallel thread tapping of the same size. This can lead to machine stops due to overload... 詳細表示

Can tapered pipe taps (TPT) be used f...

Step feeding is not recommended for tapered pipe taps (OSG series: TPT). [Reasons why step feeding is not recommended] Unlike drilling, tapping is prone to... 詳細表示

Troubleshooting: Measures for Interna...

If galling or tearing occurs on the internal thread during tapping, please check the following points. Ensure the tap is suitable for the work material. ... 詳細表示

SKS Taps What are tungsten taps?

SKS is an alloy tool steel, commonly known as tungsten. On the packaging box, it is labeled "HIGH QUALITY TAPS". No Product Name Chamfer Size No ... 詳細表示

trapezoidal screw tap ACT <special tap>

This is a tap that can be screwed accurately and easily with trapezoidal screws, and is usually finished with a single raised tap after rough threading, or a... 詳細表示

There is a P or B on the shank of the...

The “P” and “B” markings on the forming‑tap shank indicate the chamfer length. In the New Roll Tap (NRT) series, “P” (Plug) is used for through‑hole machinin... 詳細表示

Tool selection based on HRC hardness

When the material to be machined is not listed in the corresponding material column of the catalog, or when the properties have changed due to tempering, etc... 詳細表示

What are the countermeasures for thre...

Tapered pipe tapping involves a large cutting area, which increases the load and makes "galling" more likely to occur. Please consider the following. (1) ... 詳細表示