Ichirinbuto

Ichirin (一厘) is the unit used to represent size in inches. 1 inch = 25.4 mm 1 minute (ichibu) = 1/8 inch = 3.175 mm Ichirin (一厘) = 1/10 of 1 minute ... 詳細表示

What are the pilot hole diameters and...

Please refer to the following pilot hole diameter table. The table includes the following thread types: Tapered pipe thread: PT, Rc Parallel pipe thre... 詳細表示

What are the pilot hole diameters and...

Pilot hole diameter When drilling pilot holes, please refer to the "Where reamer is not used" column in the table below. Tool diameter of the tap For ... 詳細表示

SKS Taps What are tungsten taps?

SKS is an alloy tool steel, commonly known as tungsten. On the packaging box, it is labeled "HIGH QUALITY TAPS". No Product Name Chamfer Size No ... 詳細表示

Why does thread thinning occur even w...

Are you using a float-type tapping holder together with the synchronous feed mechanism? Even if the machine synchronizes the feed to one pitch per revolutio... 詳細表示

When should I use a tapped tape for p...

The short thread type (tap product name: S-TPT) is used for screwing elbows, teas, and other items with a short thread length. Since the reference diamete... 詳細表示

Pilot Hole Diameter Chart for Unified...

For Cutting Taps (Pilot Hole Diameters) (ASNI) ASME B1.1 詳細表示

Pilot Hole Diameters for Pipe Threads...

Pilot Hole Diameter Chart for Pipe Threads Taper Pipe Threads: Rc, PT, Rp, PS Parallel Pipe Threads: G, PF 詳細表示

Troubleshooting: Measures for Interna...

If galling or tearing occurs on the internal thread during tapping, please check the following points. Ensure the tap is suitable for the work material. ... 詳細表示

What should be done to prevent vertic...

What should be done when vertical streaks (stop marks) are formed in tapered threads for pipes? When tapping, vertical streaks known as "stop marks" are ine... 詳細表示