• No : 17897
  • Publication Date : 2025/09/05 11:11
  • Updated Date : 2026/01/15 10:21
  • Print

Is it possible to use non-water-soluble coolant (internal coolant) in ADO-SUS drills?

Is it possible to use non-water-soluble coolant (internal coolant) in ADO-SUS drills?

Category : 

Answer

Is it possible to use non-water-soluble coolant (internal coolant) in ADO-SUS drills?

Compared to water-soluble coolant, the cooling effect and oil discharge amount are poor, and the following problems are likely to occur.

 
  • Chipping of cutting edges due to welding up the edge
  • Breakage due to chip jamming caused by an increase in chip size
 
In order to solve the problem, we recommend the following processing method.
 
  • Reduce the cutting speed of the cutting condition table by 30%.
  • Set the feed rate per rotation of the drill to 1.5%~2% of the drill diameter.
  • Insert a step of about 20% of the drill diameter and process. However, at this time, do not pull the drill back, but stop feeding for about 0.1 seconds by Dwell.