Gauge for right angle

special products available gauge right angle degree. Please contact our sales team. 詳細表示

Difference between conventional JIS a...

WP (Working plug) represents the NOT GO plug gauge for production(Working) use in conventional JIS,while IP (Inspection plug) represents the NOT GO plug gaug... 詳細表示

What is the difference between the pi...

The figure below shows the positional relationship between the tolerances of each pitch diameter in thread accuracy and thread gauge accuracy. Positional re... 詳細表示

What gauge is used to check PS female...

Since the PS internal thread is a combination of PT external thread , a tapered plug gauge (PT) is used for pass/fail judgment. However, only if the PS inte... 詳細表示

for concentricity gauge

A gauge that measures the concentricity of connected holes with different diameters is called a concentricity gauge. It is compatible with special products. 詳細表示

The pass/fail judgment differs depend...

There are also tolerances in the angle and pitch of the gauge , and there are minute differences on the front and back. When the pitch diameter of the ext... 詳細表示

Difference between machining and insp...

Both are GO NO side screw gauges, but there is a difference in tolerance. It is recommended to use machine work (WP / WR) at the processing site, and use in... 詳細表示

What is WR?

External thread Limit gauge (LG) is used to measure former JIS metric threads and unified threads, and NO GO side ring gauges for machine work. 詳細表示

Is there a gauge of wear plugs for ta...

Wear Inspection Plug gauge for Tapering gauge for R Pipe There is no lineup of standard products. Special products ( gauge symbol: CP) will be supported.... 詳細表示

Can the ring gauge be used from both ...

Yes. In principle, limit thread ring gauges for parallel threads can be used from both sides. Since the thread from is symmetrical, there are no functiona... 詳細表示