Difference between machining and insp...
Difference between machining and inspection (WP/IP vs. WR/IR) Both are GO NO side screw gauges, but there is a difference in tolerance. It is recommend... 詳細表示
A / B is written on the GO thread gau...
The notation A/B in the accuracy column of the GO screw gauge of the parallel screws G and PF for pipes means that they can be shared in the pass/fail judgme... 詳細表示
Material welded to thread gauge
It is a precision measuring tool and guarantees the product, so it is not used to remove welding. In particular, care must be taken when inspecting alumin... 詳細表示
Is there a pass/fail decision between...
There are also tolerances in the angle and pitch of the gauge , and there are minute differences on the front and back. When the pitch diameter of the ext... 詳細表示
Which thread gauge for oversize taps?
What is the thread gauge for oversize taps? The selection of a gauge for oversized taps is incorrect. The gauge is selected according to the "accuracy o... 詳細表示
Difference in pass/fail judgment betw...
What passes for work does not pass for inspection. As long as the gauge is not worn, it should not be considered. 詳細表示
Pilot hole plug gauge for tapered thr...
It is not available as a standard product, but will be handled as a special product. In addition, we generally recommend straight holes for pilot holes duri... 詳細表示
gauge When can the inspection table web system be used from the time it is completed? It can be confirmed from the completion of April 2011. References: ga... 詳細表示
I want a brand new gauge calibration ...
If it can be confirmed as new and within 3 years from the inspection date listed in the inspection report card, it can be issued without sending the actual p... 詳細表示
The gauge for drops is thought to be a gauge whose reference surface is counterboring or the like, but it is a special correspondence. 詳細表示
Results:72 ,Showing: 21 - 30