I would like to know about the mainte...

I would like to know about the maintenance of the screw gauge . The measurement method for wear inspection is defined in JIS. Inspection method parallel... 詳細表示

How to "right" select the right threa...

How to "right" select the right thread gauge for your application? It is the [screw gauge] that guarantees the thread accuracy of the workpiece drawing inst... 詳細表示

Can the ring gauge be used on both si...

In the case of parallel screws, both sides can be used. If there is a difference in judgment, scratches or welding may be on one side. In addition, the... 詳細表示

Pilot hole plug gauge for tapered thr...

It is not available as a standard product, but will be handled as a special product. In addition, we generally recommend straight holes for pilot holes duri... 詳細表示

Do you handle CTC19 Thin Steel Condui...

It will be compatible with special products. 詳細表示

Which thread gauge for oversize taps?

What is the thread gauge for oversize taps? The selection of a gauge for oversized taps is incorrect. The gauge is selected according to the "accuracy o... 詳細表示

How to check the wear of the screw pl...

There are three ways to do this: (1) Measurement by the three-needle method JIS B0271 (2) Calibration (3) Judgment by wear inspection ring gauge T... 詳細表示

What is a Wear Inspection Screw Plug ...

The wear inspection screw plug gauge is a gauge to check whether the limit ring gauge for screws is too worn. The diameter of the limit ring gauge for scr... 詳細表示

Interpretation of force when using sc...

Interpretation of the amount of force when using screw gauge _screwing by hand without strain Regarding the use of screw gauge , JIS (JIS B 0251) des... 詳細表示

I feel that the outer diameter of the...

M8×1.25 For class 2, The outer diameter of the GO gauge (GP) is +6~+18 micrometers compared to 8. The outer diameter of the Tap varies slightly depending o... 詳細表示