What is revolution?

Revolution means how many revolutions the tool makes in one minute. In the machining program that moves the machine tool, it is expressed by "S". In calcula... 詳細表示

Even though I perform centering, the ...

When the drill starts contacting the workpiece from its shoulder, you cannot achieve accurate hole positioning. Issue Example ・Using a starting drill with ... 詳細表示

What does cutting speed mean?

Cutting speed is the speed at which the outermost part of the tool moves in one minute. Symbols are denoted by Vc. The unit is (m/min). The cutting speed (... 詳細表示

Is there a formula for calculating th...

Experimental Formulas for Estimating Thrust Force, Torque, and Required Power When considering the clamping method or fixture design for a workpiece, it is ... 詳細表示

Why does a drilled hole become polygo...

It is likely caused by drill runout during machining. Possible Causes ① Runout when mounting the drill 　Countermeasure: Keep mounting runout within 20 μm ... 詳細表示

Is a centering process always necessa...

Centering is performed to improve hole position accuracy and to suppress unstable behavior at the hole entrance during machining. However, if there is no st... 詳細表示

Do you need to drill a pilot hole bef...

Do you need to Pilot hole for large drilling? If you have enough mechanical horsepower, you don't need Pilot hole. When machine horsepower is insufficient,... 詳細表示

What is the maximum hole depth that c...

A drill removes material while continuously evacuating chips through its flutes. It is essential that chips are discharged outside the flutes during drilling... 詳細表示

What is the feed rate of a drill?

Feed rate is how far the tool moves per minute. The unit of feed velocity (Vf) of the drill is (mm/min). The feed rate can be calculated by multiplying the... 詳細表示

Is there a tool to remove a broken tap?

Yes. Please use the “EX-H-DRL” Tap Removal Drill (also known as the Hard Drill). This drill is designed to crush the core of the broken tap and remove it. M... 詳細表示