What is a back taper? The outer diameter of the drill is tapered from the tip to the shank, and it is attached to avoid friction with the inner surface ... 詳細表示
What is point angle Effects of Drill...
What is point angle Effects of Drill point angle point angle is the angle of the tip of the drill. In general, 118° is the standard for high-speed steel dr... 詳細表示
What is a shank with a tang? It is a shank with two flat sides at the end of the shank. The tang is mainly used for detenting. For our drills, only ... 詳細表示
What is step feeding? G83 Step feeding is the action of stopping the hole drilling in the middle, taking the drill out of the hole once, and then drilli... 詳細表示
What is the drill step increment for ...
External Lubrication; ・For vertical machining centers: No step drilling up to 3D. Beyond 3D, use step increments of 1D to 2D as a guideline. (D = drill dia... 詳細表示
Thinning is a process in which the chisel edge (the non-cutting edge) of the tip of the drill is thinned so that the cutting edge is applied to the center of... 詳細表示
The effect of the helix angle of the ...
The standard helix angle is 30°. A low helix angle reduces sharpness but increases cutting‑edge strength. A high helix angle provides a sharper edge but lo... 詳細表示
What is pick milling (Peck Processin...
What is peck feeding (High-speed step feeding) G73 peck feeding is a method of forcibly separating chips by separating the cutting edge from the machining p... 詳細表示
What do 2D, 3D, 4D, and 5D mean?
What does 2D, 3D, 4D, and 5D mean? D stands for tool diameter. It is expressed as several times the depth and length of the tool diameter, and is express... 詳細表示
Flute length is the length from the tip of the drill to the end of the flute. The drill must have space to evacuate the chips that arise during machining. M... 詳細表示
Results:12 ,Showing: 1 - 10