We have compiled a list of frequently...

The 3D sensor is an ideal centering device for workpiece origin setting and parallel alignment. Since no offset input is required, human errors such as data... 詳細表示

☆ We have compiled a list of frequent...

Frequently Asked Questions of the Eco-Cut Series *You can view the Eco-Cut catalog here. ・ Is there a tool that can be used more efficiently for lathe machi... 詳細表示

We have compiled a list of frequently...

HAIMER "Shrink Fit Holder" How can I request a quotation for a HAIMER shrink fit holder? What are the advantages of shrink fit holders? How to use the coo... 詳細表示

☆ We have compiled a list of frequent...

You can refer to the materials related to screws from the link below. OSG Co., Ltd. Official Homepage ~Technical Information~ TECHNICAL DATA "Screws": You... 詳細表示

☆ We have compiled a list of frequent...

We have compiled a list of frequently asked questions about the representative stainless steel<sus>of difficult-to-cut materials.</sus> ・ In ord... 詳細表示

Coating performance of tools < coating >

Coating performance of tools < coating > There is a list by coating type. You can refer to it from the website of OSG Coating Service Co., Ltd.... 詳細表示

Hardness Conversion Table

Hardness Conversion Table OSG's general catalogue has an approximate hardness conversion table for the Rockwell C hardness (HRC) of steel. Please use i... 詳細表示

We have compiled a list of frequently...

Centro is a device that allows you to center round holes and round bosses quickly. The dial indicator is easy to read because it does not rotate, and table ... 詳細表示

☆ We have compiled a list of question...

For those who are new to the industry and new employees, we have compiled basic terms and inquiries. * If there is anything else you would like to know or w... 詳細表示

What is OSG Group's regrinding and re...

The OSG Group not only manufactures tools, but also regrinding and recoatings. While making the most of the know-how of tool manufacturers, we contribute to... 詳細表示