Can the effective thread length be in...
The limit gauge measures the fit, not the length correctly. Since there is a chamfer and an incomplete pile at the tip of the thread, it is not possible to ... 詳細表示
Gauge to measure internal thread mi...
What is a gauge that inspects the minor diameter of a internal thread ? It is called "Plug Gauge for minor diameter ". It is a standard stock item. ... 詳細表示
Pipe taper gauge (R and PT) are not differentiated by accuracy class. There is a distinction between parallel screws for pipes gauge (G and PF). G scre... 詳細表示
The plug gauge has come off the handle
The plug gauge has come off the handle. It's okay to put it on as it is. Since they are only stuck together with a taper, please tap them lightly with a res... 詳細表示
Unified Thread Ring gauge What is th...
Unified Thread Ring gauge What is the difference between 2A and 3A? 2A and 3A are the external thread accuracy ratings for unified threads. 2A: Widely ... 詳細表示
How to check the wear of the screw pl...
There are three ways to do this: (1) Measurement by the three-needle method JIS B0271 (2) Calibration (3) Judgment by wear inspection ring gauge T... 詳細表示
Is it possible to share G, PF, and to...
Is it possible to share G, PF, and tools? Tools such as taps, threaded round dies, and other machining tools can be shared. However, the gauge must be as... 詳細表示
PT Screw Taper Angle What is the slop...
PT Screw Taper Angle What is the slope angle on one side? It is tapered by 1/16 and becomes 3°34'47". The slope angle on one side is 0.5/16 taper, 1°47'23"... 詳細表示
What is an NC thread? Is it possible ...
NC threads are American 60-degree threads. Tap can be shared, but gauge can be used as a special product. 詳細表示
I want a brand new gauge calibration ...
If it can be confirmed as new and within 3 years from the inspection date listed in the inspection report card, it can be issued without sending the actual p... 詳細表示
Results:129 ,Showing: 51 - 60