Drill selection procedure How to choo...
Step (1) Check how many times the depth of the hole to be processed is the diameter If the drill diameter (D) is 10 mm and the depth is 30 mm Calculate 30÷... 詳細表示
This is a drill with a flat tip, and the ADF and ADFO series are applicable. A flat tip shape is one in which the point angle of the drill is 180 degrees an... 詳細表示
What does drill feed rate (mm/rev) mean?
It indicates how many millimeters the drill advances per one revolution. In OSG’s drill catalog, recommended feed rates (mm/rev) are listed as ranges for ma... 詳細表示
What do 2D, 3D, 4D, and 5D mean?
What does 2D, 3D, 4D, and 5D mean? D stands for tool diameter. It is expressed as several times the depth and length of the tool diameter, and is express... 詳細表示
What is the maximum hole depth that c...
A drill removes material while continuously evacuating chips through its flutes. It is essential that chips are discharged outside the flutes during drilling... 詳細表示
What is point angle Effects of Drill...
What is point angle Effects of Drill point angle point angle is the angle of the tip of the drill. In general, 118° is the standard for high-speed steel dr... 詳細表示
How many corners can I use for insert...
The inserts of PD drills (P2D, P3D, P4D, P5D) can be used in 4 corners, and the center cutting edge and peripheral cutting edge are the same chip , so it is ... 詳細表示
Cutting speed is the speed at which the outermost part of the tool moves in one minute. Symbols are denoted by Vc. The unit is (m/min). The cutting speed (... 詳細表示
What is Dwell Machining (Drilling)
What is Dwell Machining? (Drilling) Dwell machining is a machining method that temporarily stops the progress of machining while the drill spindle is rotate... 詳細表示
Is there a tool to remove a broken tap?
Yes. Please use the “EX-H-DRL” Tap Removal Drill (also known as the Hard Drill). This drill is designed to crush the core of the broken tap and remove it. M... 詳細表示
Results:34 ,Showing: 21 - 30