How deep should the pilot hole be for...
To determine the required pilot hole depth,calculate the sum of the following elements based on the tap and the required thread depth: X: Effective thread... 詳細表示
What oversize tap should be used when...
The required tap oversize for plating is calculated based on the plating thickness . When plating is applied, the most critical dimension to consider is the... 詳細表示
What is a screw in MT6×0.75 grease ni...
What is the MT6×0.75 thread standard? The MT6×0.75 thread is a standard used for the male threads of grease nipples, defined by JIS B 1575. What is the d... 詳細表示
BA threads are British Standards (BS) threads with a thread angle of 47.5 degrees. BA Thread Standards and Basic Characteristics BA threads are threads spe... 詳細表示
What should be done if the machine st...
Tapered pipe tapping tends to require 2 to 3 times more torque than parallel thread tapping of the same size. This can lead to machine stops due to overload... 詳細表示
Troubleshooting: Measures for Interna...
If galling or tearing occurs on the internal thread during tapping, please check the following points. Ensure the tap is suitable for the work material. ... 詳細表示
What are the pilot hole diameters and...
Please refer to the following pilot hole diameter table. The table includes the following thread types: Tapered pipe thread: PT, Rc Parallel pipe thre... 詳細表示
Ichirin (一厘) is the unit used to represent size in inches. 1 inch = 25.4 mm 1 minute (ichibu) = 1/8 inch = 3.175 mm Ichirin (一厘) = 1/10 of 1 minute ... 詳細表示
There is a P or B on the shank of the...
The “P” and “B” markings on the forming‑tap shank indicate the chamfer length. In the New Roll Tap (NRT) series, “P” (Plug) is used for through‑hole machinin... 詳細表示
What is the difference between New Ro...
New Roll Tap (NRT) and High Roll Tap (HRT) are both forming tap While HRT is a rolled-finish tap with basic performance and is limited to sizes of M6 or les... 詳細表示
Results:76 ,Showing: 41 - 50